Filter
Top Products
Running the Diagnostics
To test the card's components and installation, the SETUP pro-
gram runs three different tests on the card and corresponding
cabling system as listed below:
• EEPROM Test
• Diagnostics on Board
• Diagnostics on Network
Note: Run the diagnostics before the network driver is loaded
into the system. Otherwise, your system may hang.
EEPROM Test
Read tests are performed on each register in the EEPROM.
Testing the Card
This test monitors the card and corresponding cabling system.
However, it does not test the network's condition.
Figure C-4. On-Board Diagnostics Display
CONFIGURATION AND DIAGNOSTICS
C-6
EZ Card PCI 3/31/98 4:18 PM Page C-6