Filter
Top Products
– 113 –
APPENDIX
■ DIP switch Factory presetting: All ON
*1
SW No. Function ON OFF
1 Always ON Should be set on
2 Auto Cutter Invalid Valid
3 Always ON Should be set on
4 Command emulation Star ESC/POS
5
Baud Rate See table below
6
7 Data Length 8 bits 7 bits
8 Parity Check Disabled Enabled
9 Parity Odd Even
10 Handshake DTR/DSR XON/XOFF
*1 The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch 2 = on)
Models with auto cutter: Valid (Switch 2 = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e.,
models with a tear bar). A mechanical error will occur.
Baud Rate Switch 5 Switch 6
4800BPS OFF ON
9600BPS ON ON
19200BPS ON OFF
38400BPS OFF OFF