Filter
Top Products
Instruction Manual
2
Installation
WARNING: Hard drives require careful handling, especially when being transported. If you are
not careful with your hard disk, lost data may result. Always handle your hard drive and storage
device with caution.
Hardware Installation
1. Remove the small screw from the rear panel of the enclosure.
2. Open the top panel of the enclosure by pulling the plastic pull tab.
3. If using a 5mm drive, place the two foam pads on the bottom of the drive tray. The foam
pads are not required if using an 8mm drive.
Screw Driver
(included)
Rear Panel screw
Power/Activity LED
USB mini-B
connector
Pull Tab
Foam Pads