Filter
Top Products
Instruction Manual
3
Terminal Block Power Connector
Power can be provided through the dual inputs from separate sources, if needed. One
electrical relay can be wired into an alarm circuit. The relay is connected as Normally
Closed (will open upon alarm condition).
DIP Switch Conguration
1. Alarm Enable: When ‘On’ this switch will disable alarm relay and fault LED if there is
a power failure in one supply. If only connecting to a single power source, place this
switch ‘On’ to disable alarm.
2. BSP: When ‘On’ this switch will disable the broadcast storm protection feature which
is enabled by default.