Filter
Top Products
Instruction Manual
5
the correct ON/OFF sequence as follows:
Power Off Sequence: Power off your PC system, then the Expansion
Box
Power On Sequence: Power on the Expansion Box first, then power
on your PC system.
Open the top cover of the PEX2PCI4 Expansion Box by removing the 2.
screws.
There are four PCI slots in the Expansion Box. Find an unused slot,
remove the “blank” PCI card bracket that was pre-installed from the
factory.
Insert the PCI card(s) you wish to install, into the available PCI slots,
then replace the top cover of the Expansion Box.
Connect the DVI-like* connector on the EC2PCI ExpressCard Host 3.
Adapter Card to the DVI-like port on the rear panel of the PEX2PCI4
Expansion Box.
Connect the AC Power Adapter to the power port (situated to the left 4.
of the DVI-like input) on the rear panel of the PEX2PCI4 main unit.
Turn on the Expansion Box power using the power switch next to the 5.
Expansion Cable, then power on the PC system
Connect the remaining end of the EC2PCI ExpressCard Host Adapter 6.
Card into the unused ExpressCard expansion slot of the host
computer, then power on the host computer.
Software Installation
If you find the write performance of your PCI Card is not as desired,
*NOTE: When performing this step, please ensure that the DVI port
provided by the PCI Express expansion card is not confused with a DVI
port provided by the computer video card, as this could damage the video
card, as well as the PCI Express expansion card and PCI expansion slot
board.