Filter
Top Products
Instruction Manual
5
2. Open the top cover of the PEX2PCI4 Expansion Box by removing the screws.
There are four PCI slots in the Expansion Box. Find an unused slot, remove the “blank” PCI
card bracket that was pre-installed from the factory.
Insert the PCI card(s) you wish to install, into the available PCI slots, then replace the top
cover of the Expansion Box.
3. Connect the DVI-like* connector on the EC2PCI ExpressCard Host
Adapter Card to the DVI-like port on the rear panel of the PEX2PCI4
Expansion Box.
4. Connect the AC Power Adapter to the power port (situated to the left
of the DVI-like input) on the rear panel of the PEX2PCI4 main unit.
5. Turn on the Expansion Box power using the power switch next to the
Expansion Cable, then power on the PC system
6. Connect the remaining end of the EC2PCI ExpressCard Host Adapter
Card into the unused ExpressCard expansion slot of the host
computer, then power on the host computer.
Software Installation
If you nd the write performance of your PCI Card is not as desired, please install the
ExpressBooster software supplied with your card.
1. Locate the Setup.exe le found on the driver CD. Assuming that E: is the designation for
your CD/DVD-ROM drive, double-click on E:\Utility\ExpressBooster to launch the setup
program.
2. Follow the setup on-screen instructions; ensure that there is a checkmark next to PCI Express
Card for Desktops/Servers only (leave the “ExpressCard” item un-checked). Proceed with
any further on-screen instructions to complete the installation.
*NOTE: When performing this step, please ensure that the DVI port provided by the PCI Express
expansion card is not confused with a DVI port provided by the computer video card, as this
could damage the video card, as well as the PCI Express expansion card and PCI expansion
slot board.