Filter
Top Products
Instruction Manual
3
Connecting Slave Computers
1) Connect the VGA port located on the rear panel of SV431USBAE to the VGA port
provided by the video connection on the desired computer, using an HDB15 male-to-
female cable. Please note the PC Port number, for steps 2 and 3.
2) Using a USB A-B Cable, connect the USB port that corresponds with the PC port
used in step 1, to the USB port on the corresponding computer, as shown below.
3) Optional: Using an audio cable (Speaker and Mic), connect the Speaker and Mic
ports provided by the PC port used in step 1 on SV431USBAE to the
Speaker and Mic ports located on the computer.
One USB patch cable for
both mouse and keyboard
Male-to-female
HDDB15 for VGA
Audio cable (Speaker and Mic)
4) Repeat steps 1-4 as necessary for each computer you wish to connect. Once all
computers have been connected, you can turn on all devices and computers.
OOppeerraattiioonn
Front Panel
1. Online and Selected LEDs:
When the LED turns green, the connected computer is
powered on. When a computer is selected, the
corresponding (red) LED will illuminate.
Each computer has a button associated with it on the
front panel for selection.
2. Pushbuttons:
Auto Scan
Auto Scan automatically scans through the connected computers individually, in a fixed
interval.
Please note: Keyboard and Mouse are not operable during Auto Scan.
To activate Auto Scan, press down the 3 and 4 buttons (on the front panel)
simultaneously. To exit Auto Scan, tap any one of the pushbuttons.
To change the Scan Time interval, press both front panel buttons 1 and 2 simultaneously.