Filter
Top Products
STUDER INNOTEC AJ
AJ V2.1 7/24
Maintenance
The inverters of the AJ series do not
need any special maintenance. The
casing may be cleaned with a damp
cloth (not wet).
In the case of malfunction, the inverter
should be sent back to the manufacturer
for control in its original packing.
Before sending the inverter, check the
table above.
The battery is loaded and is in
accordance to the inlet nominal tension
of the device.
The consumer devices do not have any
defects or overload for the inverter.
Should you contact your salesperson,
note the following points before calling:
(you will find this information on the label
underneath the inverter)
- Series number
- Power of the inverter
- Inlet nominal voltage of the inverter
Before sending back the inverter, do
take care that it is well packed. The
inverter must be in a stiff carton box
and be well protected on all sides by
mean of an anti-shock and isolating
layer of min. 5cm thickness.
The damages occurring during the
transport are not covered by the
warranty.
Warranty limit
The warranty period is 2 years.
It will be considered void if the unit has
suffered any physical damage or
alteration, either internally or externally,
and does not cover damage arising from
improper use like:
− Reverse of battery polarity
− Inadequate input voltage (over
voltage)
− Back-feed of the inverter output by
public network, generator or any other
source.
− Mechanical shock or deformation
specially by transport due to an
inadequate package.
− Contact with liquid or oxidation by
condensation
− Use in inappropriate environment
(dust, corrosive vapour, humidity, high
temperature,...)
This warranty will not apply where the
product has been misused, neglected,
improperly installed, or repaired by
anyone other than STUDER INNOTEC
or a company authorised by STUDER
INNOTEC. In order to qualify for the
warranty, the product must not be
disassembled or modified.
Limits of manufacturer liability
STUDER INNOTEC cannot control the
installation, use and maintenance of the
inverter. Thus, we are not responsible
for damages, costs or losses resulting
from an installation which is not in
accordance with the regulations or
inappropriate use or maintenance.
The customer is always responsible for
the use of the inverters STUDER
INNOTEC.
This device has not been designed and
is not warranted for use in life support
apparatus or any other critical device
with potential risks of important harm to
people or to the environment. We do not
accept any responsibility for any
violation of patent rights or other third
person rights resulting from the use of
the inverter.
STUDER INNOTEC keeps the right to
modify their products without previous
notice.
JT8 Remote control for AJ 1000-
2400
Functions on remote control are the
same as control and
indicator on the inverter
(see chapter Use)
Remote control should
be connected with the
inverter with the original
10m. STUDER cable or
any RJ11/6p 1:1 cable up to max 50m.