Filter
Top Products
Chapter 2 Hardware Installation and Removal 19
■ Ready to Remove status shows Not Ready in the ILOM interfaces.
FIGURE 2-5 LEDs, Attention and Locator Buttons
The Attention button enables you to activate (if inserting) or prepare to remove (if
removing) a NEM during a hot-plug operation.
The Locator button, when pressed momentarily, flashes a white light to assist in
locating the module. You can also activate the Locator LED remotely by executing a
command on the CMM.
TABLE 2-3 NEM LED Status
Ready-to-Remove
LED
Color: Blue
Location: Top
Service Action
Required LED
Color: Yellow
Location: Middle
OK LED (Power, Attention,
and Connected)
Color: Green
Location: Bottom
Status
On Off Off Ready to remove
Off On Off Service attention required
Off Off Very slow blink Standby
Off Off Slow blink Connecting links to blades
Off Off On Links connected to blades