Filter
Top Products
B-6
H8QI6/i-F Serverboard User’s Manual
Checkpoint Code Description
86h The password was checked. Performing any required programming before WINBIOS Setup
next.
87h The programming before WINBIOS Setup has completed. Uncompressing the WINBIOS Setup
code and executing the AMIBIOS Setup or WINBIOS Setup utility next.
88h Returned from WINBIOS Setup and cleared the screen. Performing any necessary program-
ming after WINBIOS Setup next.
89h The programming after WINBIOS Setup has completed. Displaying the power on screen mes-
sage next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed. Resetting the hard disk controller next.
8Fh The hard disk controller has been reset. Confi guring the fl oppy drive controller next.
91h The fl oppy drive controller has been confi gured. Confi guring the hard disk drive controller next.
95h Initializing the bus option ROMs from C800 next. See the last page of this chapter for additional
information.
96h Initializing before passing control to the adaptor ROM at C800.
97h Initialization before the C800 adaptor ROM gains control has completed. The adaptor ROM
check is next.
98h The adaptor ROM had control and has now returned control to BIOS POST. Performing any
required processing after the option ROM returned control.
99h Any initialization required after the option ROM test has completed. Confi guring the timer data
area and printer base address next.
9Ah Set the timer and printer base addresses. Setting the RS-232 base address next.
9Bh Returned after setting the RS-232 base address. Performing any required initialization before
the Coprocessor test next.
9Ch Required initialization before the Coprocessor test is over. Initializing the Coprocessor next.
9Dh Coprocessor initialized. Performing any required initialization after the Coprocessor test next.
9Eh Initialization after the Coprocessor test is complete. Checking the extended keyboard, keyboard
ID, and Num Lock key next. Issuing the keyboard ID command next.
A2h Displaying any soft errors next.
A3h The soft error display has completed. Setting the keyboard typematic rate next.
A4h The keyboard typematic rate is set. Programming the memory wait states next.
A5h Memory wait state programming is over. Clearing the screen and enabling parity and the NMI
next.
A7h NMI and parity enabled. Performing any initialization required before passing control to the
adaptor ROM at E000 next.
A8h Initialization before passing control to the adaptor ROM at E000h completed. Passing control to
the adaptor ROM at E000h next.