Filter
Top Products
10
2. Push the PROMDISK-Chip into the socket carefully until it is fully seated.
3. Check to make sure the PROMDISK-Chip is installed securely, and there are no bent pins.
To remove the PROMDISK-Chip, insert a small screwdriver between the PROMDISK-Chip and the
socket and gently pry around the edge until the PROMDISK-Chip is released from the socket.
COMPLETING THE INSTALLATION
To complete the installation, the following steps should be followed:
1. Set the configuration jumpers in accordance with Appendix E.
2. Install the IRV-3702 SBC into the CPU slot in a passive backplane.
3. Connect the applicable I/O cables and peripherals, i.e. floppy disk, IDE hard disk, monitor,
keyboard, power supply, etc.
4. Connect an IBM PC compatible keyboard.
5. Turn power on to the display monitor.
6. Turn power on to the backplane power supply.
7. After the BIOS sign-on message is displayed, press the Del key to enter the Setup Utility.
8. Reconfigure the IRV-3702 CMOS using the internal SETUP.
9. Boot the system.