Filter
Top Products
36 6 Testing the Network Adapter
Reading Sensor Data
To read sensor data, proceed as follows:
1. Start the main program (see page 35).
2. Select S
HOW SENSORS in the main menu.
A separate window will be displayed for the following sensor data:
• Temperature of the board
• Voltage on the PCI card (for PCI/PCI-X adapters only)
• Voltage on the PCI I/O lines (for PCI/PCI-X adapters only)
• Other supply voltages
In the main menu, S
HOW SENSORS changes to HIDE SENSORS.
3. You can close the window by selecting H
IDE SENSORS in the main menu.
Other windows may be opened while this window is still open, e.g. the window displaying the
configuration data.
Reading Configuration Data
To read configuration data, proceed as follows:
1. Start the main program (see page 35).
2. Select S
HOW CONFIGURATION in the main menu.
A separate window will be displayed showing:
• Device code (Device)
• Various vendor codes (Vendor)
• Interrupt no. (IRQ)
• Cache Line Size (CLS)
• Latency (Lat.)
• RAM size (RAM)
• PCI Express resp. PCI/PCI-X slot index and size (Slot)
• PCI bus clock (clk, for PCI/PCI-X adapters only)
• MAC address (MAC Addr)
• Port type (PMD-Type)
• Connector (Connector)
• Hardware revision (HW-Rev)
•Chip ID (Chip-Id)
In the main menu, S
HOW CONFIGURATION changes to HIDE CONFIGURATION.
3. You can close the window by selecting H
IDE CONFIGURATION in the main menu.
Other windows may be displayed while this window is still open, e.g. the window displaying the
VPD.