Filter
Top Products
➤ Selecting character
density and font
You can use the CPI key in setup mode to select the number of characters per inch to be printed.
You can use the Font key to select fonts.
Press the Setup key, then the Char (4) key.
Press the CPI (3) or Font (2) key (in our example, press CPI).
Use the < (2) or (3) key to set the desired character density. Confirm the
selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
If you pressed the Font key, use the < (2) or (3) key to select the desired font.
Confirm the selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
Press the Setup key. The printer is reset to the initial status. It is also possible
to press the Online key. The printer then changes directly to online mode.
Adjust Paperway
Menu Char
Online
Setup
21
3
4
Font CPI
Online
Setup
21
3
4
10 CPI *
Set < > Exit
Online
Setup
21
3
4
ROMAN NLQ
Set < > Exit
Online
Setup
21
3
4
Adjust Paperway
Menu Char
Online
Setup
21
3
4
The selection made is not retained after switching off the printer.
For details on the permanent setting of the character density, refer
to the reference manual on the online CD-ROM.
Settings Quick Start-up
22