Filter
Top Products
Important Information
This equipment generates and uses radio frequency energy and
if not installed and used properly, that is, in accordance with the
manufacturer’s instructions, may cause interference in radio and
television reception. It has been type tested and found to comply
with the limits for class B computing devices in accordance with
the specification in subpart J of part 15 of FCC rules, which are
designed to provide reasonable protection against such inter-
ference in a residential installation. However, there is no guar-
antee that interference will not occur in a partial installation. If
this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
Reorient the receiving antenna,
Relocate the peripheral away from the receiver,
Move the peripheral away from the receiver
Plug the peripheral into a different outlet, so that the
peripheral and receiver are on different branch circuits
If necessary, the user should consult the dealer or an experi-
enced radio/television technician for additional suggestions. The
user may find the following booklet, prepared by the Federal
Communications Commission, helpful: “How to Identify and
Resolve Radio-TV Interference Problems”.
This booklet is available from the U.S. Government Printing
Office, Washington DC 20402 Stock No. 004.000.00345.4.
WARNING:
To comply with FCC regulations on electromagnetic
interference for a class B computing device, the printer cable
must be shielded. To assure compliance with FCC regulations
for a computing device, use a shielded interface cable with a
metal shell connector. The use of cables not properly shielded
may result in violating FCC regulations.
This digital apparatus does not exceed the class B limits for radio
noise emissions from digital apparatus as set out in the radio
interference regulations of the Canadian department of com-
munications.
This unit complies with DOC standard C108.8-M 1983
ATTENTION: Le présent appareil numérique n’ement pas de
bruits radioélectriques déspassant les limites applicables aux
appareils numériques de la classe B prescrites dans le règlement
sur le brouillage radio- électrique édicté par le minstère des
communications du Canada.
The paper used is made of raw materials treated with a
chlorine-free bleaching process.
WARNING For continued protection against risk of fire, replace only with same type and rating of fuse.
Only trained and qualified personnel may open covers or remove parts that are not explicitly shown and described in the User
Guide as being accessible to the operator.
ATTENTION Pour ne pas compromettre la protection contre les risques d’incendie, remplacer par un fusible de même type et de mêmes
caractèristiques nominales.
Seul un personnel qualifié et formé est habilité à démonter les sous-ensembles de la machine qui ne sont pas formellement
indiqués dans le Manuel d’utilisation meme s’ils sont accessibles par l’opérateur.
This device fulfils the European standards requirements by complying with the
Directive of the Commission dated May 3, 1989 (89/336/EEC) relating to
electromagnetic compatibility and the Directive dated February 19, 1973
(73/23/EEC) relating to low-voltage electrical equipment. Conformity with the above men-
tioned Directives is indicated by the CE symbol attached to the device.
Note: Conformity may be affected by:
using interface cables not complying with the specifications
non-observance of important instructions in the operator’s manual
installing components not approved for this device by the manufacturer
unauthorized manipulation