Filter
Top Products
Getting Set Up
Setup Guide
11
Connect to a Macintosh: Ethernet-direct connection
Requirements
■ Two RJ-45 twisted-pair 10Base-T cables
■ An Ethernet-port hub
1.
Turn off your computer and the printer.
2.
Connect one end of an Ethernet cable to the Ethernet port on your
Macintosh computer. Connect the other end to the hub.
3.
Connect the other cable to the hub and the Ethernet port on the printer.
4.
If you are connecting any optional peripheral devices, such as a scanner, do
so now; refer to page 12 for guidelines. Otherwise, turn on your computer
and printer, refer to page 14.
5.
At your computer, from the Apple menu, select Control Panels, then
select AppleTalk; the AppleTalk dialog box opens.
6.
At the Connect via pull-down menu, select Ethernet built-in. Close the
dialog box.
7.
Proceed to “Macintosh software” on page 30.
N
O
T
E
For setting up the printer with a LocalTalk card, see the
PhaserShare
Networking Setup Guide.
C
A
U
T
I
O
N
The printer is not a SCSI device. Do not connect the printer to your
computer through the SCSI ports.
0389-43
2
3