Filter
Top Products
56037002 - 3 - © 2007 Telular Corporation
Installation Instructions
WARNING! DO NOT MOUNT THE UNIT YET!
This unit is a cellular communications device.
THE ANTENNA MUST NOT BE INSTALLED IN THE BASEMENT!
1. Connect the power.
Connect the Telguard TG-9 to the 12v DC power output from the alarm panel or to a 9-15v
DC (250 mA minimum) power supply. Ensure that the LEDs come on.
Important: The 2.5mm port on the side of the TG-9 is for programming and
diagnostics only. It is not a power input and installer shall not insert
any type of jack or other device into this port.
2. Check the signal strength.
Look at LED 1 and compare it to the following chart.
If the light is not green flashing or green solid, move the unit or antenna around until a green
flashing or green solid is achieved.
3. Activate the unit.
Short Trip Input 6 (the bottom two terminals). LED 2 should go from RED to SOLID GREEN.
This indicates that the unit is registered and active. This may require up to 3 minutes.
Note: If using Bell input, Bell must be connected per Table 1 on page 5 before
activating. Make sure there are no Bell alarms in progress before activating.
If a FLASHING RED appears on LED 2, the unit has failed registration. This usually indicates
that the Activation Form has not been completed. If this occurs, call Telular Technical
Support at 800-229-2326.
4. Connect the trip inputs.
The trip inputs on the TG-9 should be connected according to the TG-9 Operation Profile
selected for the unit. (Consult the installation diagram on the opposite page.) All zone inputs
require an E.O.L. resistor (supplied).
Note: If zone 1 is programmed as a bell input, do not
connect E.O.L. resistor.
5. Send test signals.
Trip zones on the system, and confirm that signals are received at the central station.
6. Connect the relay output to the alarm panel. (Optional)
The STC relay output is a Normally Closed (N.C.) contact. The zone on the panel should be
programmed as a 24-Hour Supervisory Zone.
7. Permanently mount the Telguard TG-9
Green Solid Good Signal Strength
Green Flashing Acceptable Signal Strength
Yellow Flashing Weak Signal Strength
Red No Signal Strength