Filter
Top Products
Bill of Materials
3-5
Schematic, Physical Layouts, and Bill of Materials
3.3 Bill of Materials
Table 3–1 lists materials required for the EVM.
Table 3–1.Bill of Materials
Item#
bq24010
–1
bq24012
–2
Ref
Des
Description Size MFR Part Number
1 0 0 C1 Capacitor, ceramic, X5R,
1 µF, 10 V
805 Panasonic ECJ-2YB1A105K
2 1 1 C2 Capacitor, ceramic, X5R,
1 µF, 10 V
805 Panasonic ECJ-2YB1A105K
3 1 1 C3 Capacitor, ceramic, X7R,
0.47 µF, 16 V
805 Panasonic ECJ-2YB1C474K
4 1 1 D1 Diode, LED, red, 1.8 V,
20 mA, 20 mcd
603 Lite-On 160-1181-1-ND
5 2 2 D2, D3 Diode, LED, green, 2.1 V,
20 mA, 6 mcd
603 Lite-On 160-1183-1-ND
6 1 1 J1 Terminal block, 2 pin, 6 A,
3,5 mm
0.27 × 0.25 OST ED1514
7 2 2 J2, J3 Terminal block, 4 pin, 6 A,
3,5 mm
0.55 × 0.25 OST ED1516
8 3 3 J4, J5,
J6
Header, 3 pin, 100 mil
spacing, (36-pin strip)
0.100 × 3 Sullins PTC36SAAN
9 3 3 R1, R2,
R5
Resistor, chip, 1.5 kΩ,
1/16 W, 1%
603 Std Std
10 2 0 R3, R6 Resistor, chip, 1 MΩ,
1/16 W, 1%
602 Std Std
11 0 1 R6 Resistor, chip, 10 kΩ,
1/16 W, 1%
603 Std Std
12 1 1 R4 Resistor, chip, 1.3 kΩ,
1/16 W, 1%
603 Std Std
13 1 0 U1 IC, single Li-Ion/Li-Poly,
charge manager
MLP10 TI bq24010DRC
14 0 1 U1 IC, single Li-Ion/Li-Poly,
charge manager
MLP10 TI bq24012DRC
15 3 3 — Shunt, 100-mil, black 0.100 3M 929950-00
16 1 1 — PCB, bq24010/2,
1.6 in × 1.3 in × 0.031 in
Any SLUP162
Notes: 1) These assemblies are ESD sensitive; ESD precautions must be observed.
2) These assemblies must be clean and free from flux and all contaminants. Use of no-clean flux is not acceptable.
3) These assemblies must comply with workmanship standards IPC-A-610 Class 2.
4) Reference designators marked with an asterisk (**) cannot be replaced by substitutes. All other components can
be replaced with equivalent manufacturer components.
3.4 Reference
1) bq2401x data sheet (SLUS530)