Filter
Top Products
24
Interconnect cables damaged
Make sure that the integrity of your interconnect cables is sound
and they are firmly connected to your turntable and the SXV1.
SXV1 is close to external interference
Check the proximity of your SXV1 to any possible source of
EMI and/or RF interference, for example computers, televisions,
amplifiers, speakers, etc. Ideally the SXV1 should be placed as
close as possible to your turntable.
Earth loop in system
If your preamplifier and/or amplifier have an earth/ground lift
switch, toggle it and check which setting sounds better. The
signal ground of the SXV1 is isolated from earth by default, this
means that there needs to be a connection to earth elsewhere in
your system to alleviate hum.
My speaker
cones are
moving
excessively
at low
frequencies
Tone arm set up incorrectly
Check that your tone arm is set up correctly and it is properly
weighted and balanced.
Turntable susceptible to vibration
Make sure that your turntable is solidly mounted on a surface that
not prone to vibration.