Filter
Top Products
TM
Purepower Series
TM
Purepower Series
3. Power Connector Introduction
Connector Type Connectors & Cable length
20+4pin
ATX 12V 4pin
SATA
4. Installation Steps
03 04
Cable
P/N Model
W0330 550W
W0329 450W
1 1 4 6 2 1
1 1
2
5
1
1
1. Open your computer case; please refer to the direction in your
case manual.
2. Install the PSU into the case with the four screws provided.
3. Connect the 24 pin Main Power Connector to your
motherboard and peripheral. If your motherboard uses a 20-pin
connector, detach the 4-pin attachment on the 24-pin connector.
4. Connect the 8-pin or 4-pin connector for the CPUs.
5. Connect other peripheral power connectors to devices such as
hard drives, optical drives, etc.
6. Close your computer case and connect the AC power cord to
the power supply AC inlet.
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V
connector.
Note: Make sure that your system is turned off and unplugged.
Disconnect the AC power cord from your old power supply.
20+4pin Main
Connector
4pin +12V CPU
Connector
SATA
Connector
Peripheral
Connector
Floppy
Connector
6pin PCI-E
Connector
W0328 350W
1 1
2
5
1
0
MODELS
W0330
W0329
W0328
Molex & FDD
W0330
W0329
W0328
W0330
W0329
W0328
W0330
W0329
SATA
PCI-E 6pin
1 x 24pin Main connector
(400mm)
1 x ATX 12V 4pin connector
(400mm)
3 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm + 150mm)
3 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm + 150mm)
3 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm + 150mm)
2 x Peripheral connectors
(400mm + 150mm)
3 x Peripheral connectors
(400mm + 150mm + 150mm)
2 x Peripheral, 1 x FDD connectors
(400mm + 150mm + 150mm)
2 x SATA connectors
(400mm +150mm)
2 x SATA connectors
(400mm +150mm)
2 x SATA connectors
(400mm + 150mm)
1 x 6pin PCI-E connectors
(400mm)
250x176mm