Think Outside Tablet Accessory Tablet Accessory User Manual


  Open as PDF
of 3
 
1. Setup a Secure connection.
a. Scan and discover as described above, then check the Secure box and tap Connect.
b. When prompted enter a numeric-only passkey (of your own choosing) on the PDA’s
On-Screen keyboard using the stylus and tap OK.
c. Type the same passkey on the keyboard using LFn+number and Enter.
2. Set the PDA to accept pairings from All devices.
NOTE: This is a vulnerable configuration (consult the Owner’s Manual for details).
a. On the PDA, open Bluetooth Settings.
b. Open the Accessibility tab and select All devices.
NOTE: If applicable, the above steps may be done automatically by tapping Make PDA accessible
during the initial configuration of an unsecure connection.
Removing and Replacing the Stand (optional):
1. Place keyboard on a flat surface and pull stand with a slight rotating motion.
2. Replace stand by aligning clips and pressing until it snaps into place.
For more comprehensive instructions please refer to the electronic Owner’s Manual located on the CD-ROM.
©2005Think Outside, Inc. All rights reserved.
Reproduction of this document in any manner whatsoever without the written permission of Think Outside, Inc. is
strictly forbidden.
Trademarks used in this text: Stowaway is a trademark of Think Outside, Inc. The Bluetooth word mark and logos
are owned by the Bluetooth SIG, Inc. and any use of such marks by Think Outside, Inc. is under license.
ActiveSync is a registered trademark of Microsoft, Inc.
Other trademarks and trade names are those of their respective owners. Think Outside, Inc. disclaims any
proprietary interest in trademarks and trade names other that its own.
P/N: 101880C
 previous