Filter
Top Products
4The SpeedTouch
TM
610 SNMP
Application Note Ed. 01
25
ADSL and SHDSL MIBs Following two MIBs are specific per SpeedTouch
TM
610 variant (ADSL or SHDSL vari-
ants). You should only load the appropriate one, although loading both will not harm
functionality. To retrieve maximum SNMP information it is imperative to use the MIB
provided on the CD-rom, and not the one supported (if so) by the SNMP manager.
• RFC2662 ADSL MIB (containing ADSL-LINE-MIB and ADSL-TC-MIB)
The ADSL MIB is in fact a bundle of three MIBs: the ADSL-LINE-MIB, the ADSL-
TC-MIB and additionally the PerfHist-TC-MIB. It contains management informa-
tion about the ADSL line such as Signal-to-Noise Ratio (SNR), output power and
attainable bit rate.
• HDSL2-SHDSL-LINE MIB (containing SNMP-FRAMEWORK-MIB)
The SHDSL MIB contains management information about the SHDSL line such as
Signal-to-Noise Ratio (SNR), Loop attenuation, PSD regional setting, line rate and
line status.
SpeedTouch
TM
610
specific MIBs
Following MIBs are specifically designed for the SpeedTouch
TM
610:
• System MIB (Enterprise specific branch MIB)
This required MIB is for adminitrational use by the other MIBs only. It provides the
object IDs (OID) from the SpeedTouch
TM
610 specific MIBs and defines the Enter-
prise specific object identifier.
• IPSec MIB (Product specific)
The SpeedTouch
TM
610 specific IPSec MIB contains management information
about the IPSec protocols (in case IP VPN IPSec functionality has been enabled via
the appropriate SpeedTouch
TM
610 software key). Details are given of Security
associations, tunnel statistics and errors.