Filter
Top Products
5
Getting Started
T105 IB
April 14,08
152mmw x 152mm H
Color: Black
Setting Clock Time and Alarm Time
Setting Clock Time
1. Press and hold the Time Button until the time display flashes. (If no time-set buttons are pressed within a few seconds,
the display will stop flashing and return to normal mode).
2. Press the Hour Button to advance the hour (a PM Indicator is on the upper right of the display; there is no AM indicator),
then press the Minute Button to advance the minutes to the correct time. Note: hold the hour or minute button to
advance clock rapidly.
3. Press the Time Button when the correct time is displayed. Two beeps will confirm that clock setting is complete.
NOTE: This unit comes with a Daylight Savings Time (DST) Switch (located on the bottom of the unit) to make
adjusting for Daylight Saving Time simple. Just move the DST Switch to +1 to add an hour or to -1 to subtract an hour
from the current time. When the DST switch is set to +1, a DST Icon will appear on the upper right of the display.
Setting Alarm Time
1. Press and hold the Alarm Set/Reset Button until the alarm time display located at the lower right of the display flashes.
(If no alarm-set buttons are pressed within a few seconds, the display will stop flashing and return to normal mode.
2. As above, press the Hour Button and Minute Button to set the desired alarm time (press and hold hour or minute button
to advance display rapidly). As with clock setting, the PM Indicator appears at the top of the alarm time display; there is
no AM indicator.
4. When the desired alarm time is displayed, press the Alarm Set/Reset Button again to return normal mode. Two beeps
will indicate Alarm Setting is complete.
Installing the Backup Battery
If the Backup Battery has been installed and a power failure occurs or the
AC cord is accidentally disconnected, the current time and alarm time
settings will be temporarily maintained.
If the Backup Battery has not been installed or is dead, when the AC
power resumes the display will show 12:00 and you must reset the time
and alarm settings.
1. Open the battery compartment cover located on the bottom of the unit.
2. Install a CR2032 battery.
3. Close the battery cover.
AC adaptor
The unit comes with an AC adaptor that must be used to power the unit (do not try to run on back up battery).
Plug the cable into the DC jack located inside battery compartment on the bottom of unit and plug the other end into AC wall
outlet.
Maintenance
Protect your furniture when placing the clock on natural wood or a lacquered wood finish. A cloth or other protective material
should be placed between the unit and the furniture.
Clean the casing with a soft cloth moistened only with mild soap and water. Stronger cleaning agents may damage the
surface of the case.
Installation of Backup Battery