Filter
Top Products
Topcom UBR 624 5
Topcom UBR 624
ENGLISH
1 INTRODUCTION
Please read this installation guide very carefully before you connect your USB ADSL modem and USB printer to the
UBR 624. The installation process should be followed step by step according to the description in this manual.
2FRONT PANEL AND CONNECTION PANEL
2.1 LED’S AND RESET BUTTON
• Reset Button: press the reset button while you plug in the power to the router. All router settings will be restored
to default settings.
• Power: the power LED will be On when the power is connected
• M1: will flash during normal operation
• LINK/ACT: the Upper LED will be on when a computer is connected to the Ethernet port. The LED will blink during
data traffic. The Lower LED will be on when a 100MBit network card is connected. This LED will be off for 10MBit
network cards.
• USB (upper LED): will be on when the USB modem is connected. This LED will blink during data traffic.
• USB (lower LED): will be on when the USB printer is connected. This LED will blink during data traffic.
2.2 CONNECTION PANEL
• 5VDC: power connection (5V DC)
• Upper USB: to connect to your USB ADSL modem
• Lower USB: to connect to your USB printer
• Ethernet ports 1..4: to connect to the computers
3 INSTALLATION
Your USB ADSL modem must already be installed on one of your computers. The installation of the USB ADSL modem
on the UBR 624 should be done on this specific computer where the USB ADSL modem drivers are installed.
All computers should have a pre-installed network Ethernet card to connect to the UBR 624.
3.1 CONFIGURING THE PC TO CONNECT TO THE UBR 624 ROUTER
If you do not wish to set a static IP address on your PC, you will need to configure your PC to accept the IP address
that the router will provide.
Your USB ADSL modem must already be installed on the computer
before you start the installation of the UBR624.
RESET
1
2
3
4
USB1
POWER
LINK/ACT
SPEED 10/100
M1
USB2
5 VDC
1234USB
Remark
- The routers default IP address is: 192.168.1.1
- DHCP server is ON
HL_UBR624.book Page 5 Monday, December 22, 2003 4:02 PM