Filter
Top Products
E7-1
7. INSERTING THE OPTIONAL PCMCIA CARD
EO1-33008
7. INSERTING THE OPTIONAL PCMCIA CARD
7. INSERTING THE OPTIONAL PCMCIA CARD
1. Turn the power off.
2. Insert the PCMCIA card into the card slot at the rear of the printer.
3. Turn the power on.
NOTES: 1. Be sure to protect a PCMCIA card when not in use in the printer by putting it in its protective
cover.
2. Do not subject the card to any shocks or excessive forces.
3. Do not expose the card to extremes of heat by either storing in direct sunlight or close to a
heater.
4. Do not expose the card to excessive humidity by wiping it with a wet cloth or storing it in a damp
place.
5. Before inserting or removing the card, make sure that the power switch is turned off.
6. The following PCMCIA cards can be used.
Fig. 7-1
PCMCIA Card
1
0
CAUTION:
1. To protect PCMCIA cards, discharge static electricity from your body by touching the printer rear
cover prior to touching the PCMCIA cards.
2. Before turning off the power when using ATA card, be sure to press the [PAUSE] key and check
the ON LINE LED is unlit. Failure to do this may erase the data which is being written to the ATA
card.
WARNING!
Turn the power OFF when inserting or removing the PCMCIA card.
Type
ATA Card
LAN Card
Flash Memory
Card (4 MB)
Maker
3 COM
Description
Ether Link III 3C589D PC
card
Remarks
Install into the slot (1) only.
(This card installed into the
slot (0) will not work.)
A card conforming to the PC card ATA standard
Maxell
EF-4M-TB CC
EF-4M-TB DC
7. Install the LAN card into the slot (1).