Filter
Top Products
- 15 -
EO1-11113
PROGRAMMING JOB LIST
Master: Programming is available on the master terminal (when the [RTR] key is turned on
or the INLINE lamp is on).
Satellite: Programming is available on the master terminal (when the [RTR] key is turned off
or the INLINE lamp is off), the backup master terminal and the satellite terminal.
1 Store Name/Message, Commercial Message Programming
2 Cashier Code and Name Programming
4 PLU Table Programming
5 Time Setting or Adjustment
6 Date Setting or Adjustment
8 Amount Limit Setting for Function Keys
15 Customer File Code (Check Track No.) and Name Setting
20 Salesperson Code and Name Programming
26 Tare Table and General Unit Weight Setting
27 PLU Preset-code Key Setting
31 Display Message Programming
35 Negative Amount Key Limit Amount Setting
42 Set Menu Table Programming
Department Preset Price Setting or Changing
PLU Preset Price Setting or Changing, Whole Package Quantity Changing
% + and % - Preset Rate Setting
Preset Rate Setting for Selective Itemizers
Foreign Currency Exchange Rate Setting
Tax Table Programming
GST Rate Setting
Store/Register No. Setting
4. PROGRAMMING OPERATIONS
The system should be programmed fully by your local TOSHIBA TEC representative at the time of
delivery according to the user’s requirements so that daily operations can immediately start.
However, some data must be added or changed daily or in a longer period. Since the volume of
programming contents for the system is too large, this chapter and the following two chapters are
provided as guide lines of the user’s daily programming and maintenance operations. If there are
any unclear points or program data other than listed here must be changed or added, please contact
your TOSHIBA TEC representative. Please also note that some programming operations introduced
in the Standalone Level are modified or not available on in-line terminals.
PROGRAMMING OPERATIONS COMMON WITH STANDALONE
ECR LEVEL
The following is the table of programming operations which are introduced in the Manager’s
Guide for the Standalone Level and can be operated on in-line terminals as well, with the
Submode No. and operation sequence unchanged. However, on in-line terminals, these are
usually operated on the Master Terminal only and down-line-loaded (DLLed) to all the Satellite
Terminals. Therefore, if any program data is changed, a DLL is further necessary to Ioad the new
data (after the change) to all the Satellite Terminals (to be described in Chapter 5).
Submode No.
Terminals
No
Submode
O
Programming Job
Master Satellite
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O: Available