Toshiba EQPIII-841 Power Supply User Manual


  Open as PDF
of 2
 
DesigneD for the Petro-Chem market
MOTORS ADJUSTABLE SPEED DRIVES CONTROLS UPS INSTRUMENTATION PLC
INDUSTRIAL DIVISION
13131 West Little York Road, Houston, Texas 77041
Tel 713/466-0277 Fax 713/466-8773
US 800/231-1412 Canada 800/872-2192 Mexico 01/800/527-1204
www.toshiba.com/ind
Copyright 2/2008
Available Through:
*LVMEqp3841080210*
Toshiba’s EQPIII-841 motors are designed for the harshest environments where
premium performance and reliability are a must. These motors are built to meet or
exceed IEEE standard 841-2001 specications and are designed to meet NEMA
Premium
®
efciency levels. In addition, the EQPIII-841 is provided with CSA
approval and UL component recognition.
Nameplate
• Stainless Steel
• NEMA Premium
®
Design
• Raised Letters for Clarity
• Inverter Duty Rating on
Nameplate
(1 to 200 HP, 4 & 6 pole)
• Seperate Lubrication
Label
• Compliance with IEEE 841
Standards
Conduit Box
•
Gasketed Cast Iron
•
UL Ground Lug
•
Lead Separation
Protection
•
Protective Internal
Coating
•
12-Inch Minimum
Lead Lengths
•
Terminal Lugs on All
Frame Sizes
Bearing System
• Re-Greaseable Oversized
300 Series Bearings on
All Frames and Both Ends
• Low Temperature Rise
for Extended Life
• L-10 Bearing Life of
150,000 Hours Direct
Coupled
• L-10 Bearing life of
50,000 Hours Belted
•
Inpro/Seal
®
on All
Frames, Both Ends
• Open Regreaseable
Bearings, All Frames
Insulation System
• System’s Major Components
Made from Class-H Materials
• Low Loss Electrical Steel
with 1000ºF
Burnout Capability
• System Meeting NEMA
MG1 Part 31
• Voltage Withstand Capbility of
2000 V in 0.1 Inches/Second
• Large Thermal Margins for
Extended Life and Reliability
• Phase Paper and Coil Bracing
on Both Ends on All Ratings
• Heavy-Build Class-H Varnish
with Additional Insulation
Barrier
• 150°C Rated
Lead Cable
Construction
• Cast Iron Frame and
Bearing Brackets
• Multi-Mount Construction
• Gasket Provided Between
Motor Frame and Conduit
Box
• Typical Unfiltered
Vibration Levels of 0.04
Inches/Second or Less
• Protective Coating on
All Internal Machined
Surfaces
• IP55 Protection
• Breather Drains
•
100% No-Load Commercial
Test on All Motors
•
Vibration Test on All Motors
•
100% Inspection of Foot-
Flatness and Shaft Runout
on All Motors
•
On 440 Frame & Larger,
100% of Bearings are
Ball-Pass Frequency Tested
•
Commercial and Vibration
Test Report Supplied with
Motor
Testing
EXTREME MOTOR PRODUCTS
EXTREME MOTOR PRODUCTS EXTREME MOTOR PRODUCTS
EXTREME MOTOR PRODUCTS
 previous