Filter
Top Products
2.5” Hard Disk Drive Installation Notes - P/N 480070-B0 P/N 480070-B0 2.5” Hard Disk Drive Installation Notes -
MK1234/1034/8034/6034/4034GSX 05/06 05/06 MK1234/1034/8034/6034/4034GSX
Logical Drive MK6034GSX MK4034GSX
Parameters HDD2D35 HDD2D39
# of Cylinders (user) 79,056 60,912
Bytes per Sector 512 512
LBA Sectors 117,210,240 78,140,160
Buffer Size (KBYTES) 8,192 8,192
Rotation Speed (±.1%) 5400 5400
Transfer Rate 245 – 475 199– 434
Internal (MBITS/sec.)
# of Cylinders (logical) 16,383 16,383
# of Heads 16 16
# of sec./Track 63 63
Host Transfer Rate 150MB/s 150MB/s
Seek Time (MSEC.)
Average 12 12
Track-to-track 2 2
Maximum 22 22
UNPACKING PROCEDURE
Visually inspect the shipping container prior to unpacking for any signs of damage to
the container or its contents (the carrier is responsible for any damage incurred during
shipment). The drive is a precision device and even a small drop onto any surface can
cause damage. Prior to opening the anti-static bag, it is recommended that the user
ground themself with a ground strap or by touching the PC chassis or other metal object.
Remove the drive from the anti-static bag and check it for damage. Place the drive on the
anti-static bag while configuring jumpers to avoid any electrostatic discharge. Save the
shipping container and packing material for possible use later.
INSTALLATION INSTRUCTIONS
Note: Toshiba’s 2.5” HDDs are primarily used in notebook devices. Installation into
a notebook varies depending on the system manufacturer. Toshiba’s 2.5” drives that
are installed into a desktop PC require a 3.5” installation kit.
1. Determine mounting configuration (can be mounted in either a horizontal or ver-
tical orientation).
2. Configure drive for system application.
3. When connecting the drive and host system with Serial ATA cable, use of a Serial
ATA 1.a specification compliant cable is recommended.
4. Refer to applicable manuals for software installation instructions.
Single Segment S1
Power Segment P1
Factory use
FIGURE 1 – 2.5" HDD JUMPER LOCATIONS
FIGURE 2 – MOUNTING HOLE LOCATIONS
INTERFACE CONNECTOR
Drive Side Connector Molex RSD97799-015 or equivalent
for board Right Angle Type: Molex 67492-0221,
67492-0222 or equivalent
for cable Molex 88750-5318 or equivalent (for
signal). No recommendation now for power
segment.
Recommended
Host Side
Connector