Filter
Top Products
3M
™
Multimedia Projector MP7630
24
© 3M IPC 2000
L
o
c
k
M
P
7
6
30
D
L
P
A
T
E
X
A
S
I
N
S
T
R
U
M
E
N
T
S
P
R
O
D
U
C
T
Attaching the Optional Video Module to the MP7630
S
T
A
N
D
B
Y
/
O
N
M
P
7
6
3
0
M
E
N
U
E
X
IT
1. Precisely align the two metal tabs on the bottom of the module and insert into the corresponding
slots on the back of the projector.
2. Slowly push the module to fit with the unit. Make sure that the module plugs into the AV con
nection on the projector.
3. Plug the correct cable into the corresponding jack or port in the back of the unit.
4. Select inputs by pressing SOURCE key, and select the appropriate source channel by pressing
CHANNEL UP/DOWN.
Optional Video Module
Caution
Switching Input Signals
Pressing the Source button on the remote control or the projector will cycle between these choices
of input signals: RGB (computer), Video (composite video from a VCR), S-Video, and Tuner. The
projector will then search for the selected type of signal until it is found or switched to another type.
Scanning Channels
The MP7630 can receive over 100 television channels. In Tuner mode (TV and CATV), press the
Scan button on the remote control to view all available television channels. The message “DO YOU
REALLY WANT TO SCAN? YES NO” will appear onscreen. Press either the left or right arrow
buttons on the remote to reach Yes or No, then press the Menu button to enter the selected answer.
The message “TUNER IS SCANNING NOW” will display for a few seconds, and then the scanned
channels will appear for a few seconds each.
Source button
Scan button Left and Right buttons
Power down the projector before connecting the Optional Video Module or any other
device. Failure to do so may cause serious damage.