Filter
Top Products
17
Q & A
Q: How to connect the cable modem to the hub/switch via the 10BASE-T ?
A: Cable Modem is connected to the uplink port on the hub/switch, or use cross-over
Ethernet cable to connect the normal port on the 10BASE-T hub/switch.
(See below)
Q:How to connect the Cable Modem to the PC via the USB ?
A: Plug the Type A end of the USB cable into the USB port of your PC. And plug the
Type B end of the USB cable into the USB port located in the back of Cable Modem.
(See above)
NOTES: Macintosh computers do not support networking through USB.
Mac users must use an Ethernet connection.
Q: Do I need to turn off the Cable Modem ?
A: No. You can leave Cable Modem powered up.
Q: How can I connect multiple PC to the Cable Modem?
A: You can use 10BASE-T and USB interfaces simultaneously, and also can use a
10BASE-T hub or switch for physical connection. Cable Modem is controlled by the
Cable Operator to allocate how many PCs are available. Please contact your local
Cable Operator to activate multiple PCs under the Cable Modem.
Cross-over Cable
or connect to
uplink port
Cable Modem
Cable TV Coax
PC
PC
HUB/ Switch
10BASE-T
USB Cable