Filter
Top Products
User’s Manual 3-27
PORTÉGÉ M780
11. Screw in the two screws and replace the memory module cover.
Figure 3-10 Seating the memory module cover
12. Insert the tabs on the front of the keyboard into the corresponding
notches on the computer and place the keyboard down.
13. Replace the keyboard and secure it using the two screws.
Figure 3-11 Replace the keyboard
14. Set the keyboard brace into its groove and hold down to secure the
latches.
15. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes, for details.
1
2
1. Screws
2. Memory module cover
When seating the keyboard, be sure to connect the circuit board if the
keyboard ribbon cable was pulled out while you were removing the
keyboard.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure no foreign matter can be found
inside the computer.
1
2
3
1. Screws
2. Keyboard
3. Tabs