Filter
Top Products
Chapter 4 Replacement Procedures
4.12 System board
CAUTION: 1. when handling the system board, always hold by the edges. Do not touch
the printed circuit face.
2. if replacing with a new system board, execute the subtest01 Initial
configuration in section 3.3 “Setting of the hardware configuration”.
Removing the system board
The following describes the procedure for removing the system board (See Figure 4-12-1).
1. Disconnect the LAN FFC, LCD CABLE, ANTENNA, I/O board FFC, USB FFC,
CRT cable, BT wire, SIM FFC, TP board FFC, Power Board FFC, DC-IN cable
from the connector on the system board.
2. Remove the following screws securing the system board and remove the system
board.
M2.03.0 screw x2
Figure 4-12-1 Remove the system board
Satellite T130, Satellite Pro T130, and PORTEGE T130 Maintenance Manual (960-Q08)
45