Filter
Top Products
4 Replacement Procedures
Tecra A3/S2 Series Maintenance Manual 4-31
4.14 Touch Pad
Removing the Touch Pad
To remove the Touch Pad, first remove the top cover, then follow the steps below:
1. Remove two black M2.5x3 screws securing Touch Pad board FFC cable.
2. Remove FFC cable.
3. Remove one black M2.5x3 screw securing Touch Pad’s frame.
4. Push the Touch Pad’s frame forward and remove the Touch Pad bracket.
Figure 4-27 Removing the Touch Pad board
Installing the Touch Pad
To install the Touch Pad, follow the steps below and refer to the figures in the preceding section:
1. Secure Touch Pad Bracket with one black M2.5x3 screw.
2. Connect the Touch Pad board FFC cable to the Touch Pad, and then secure it with two black
M2.5x3 screws.