Filter
Top Products
2
The following steps must be performed to properly install your DVD Writeable drive.
z Set drive’s jumpers
z Connect audio cable
z Attach IDE BUS cable
z Connect power cable
z Mount DVD Writeable Drive
z Install Nero6 Ultra Edition Software
SETTING JUMPERS
The mode select jumpers are six (6) straight pins located on the rear of the DVD
Writeable Drive. By placing a jumper on the pins, you can select the following
functions:
CS: – Drive is configured using host interface signal CSEL
SL: – Configures drive as Slave
MA: – Configures drive as Master (default mode)
Mode Select Jumpers
In most installations, the jumper should remain in the MA (Master) position (fac-
tory default). It is recommended that you install your DVD Writeable drive only
on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard
drive would then be the Master, and you should set your drive to the Slave position
(SL).
PLACING DVD WRITEABLE DRIVE INSIDE YOUR COMPUTER
Now that you have set your drive’s jumpers, you are ready to install your
DVD Writeable drive inside your computer.
☞☞
☞☞
☞
IMPORTANT: Disconnect power from your computer system before
beginning installation.
C
S
S
L
M
A