Filter
Top Products
CONTENTS
22
Operations
Notes
•“
” is displayed on the screen if the
projector does not receive any signal from the
connected equipment. Put the equipment in
playback mode.
• Due to the lamp characteristic, flickers may
occasionally occur in a picture. This is not
malfunction of the unit.
• When an RGB source is selected and no
signal is sent from the computer for about 30
minutes, the projector turns to standby mode
for power saving. It automatically turns on
when the signal resumes. Pressing
ON/STANDBY also turns it on.
• While operating the projector, “
” may be
displayed on the screen. This means that the
operation cannot be completed.
Turning the power off
1) Press ON/STANDBY after using the
projector.
An instruction message appears.
2) Press ON/STANDBY again.
The LAMP indicator turns off, and the
projector turns to standby mode. (The ON
idicator lights in orange.)
3) After confirming the exhaust fan stops,
unplug the power cord.
The ON indicator turns off.
(Continued)
(Continued)
Notes
• Even after turning the power off, the intake
and exhaust fans continue to work for about 3
minutes more to cool the inside of the
projector.
• Immediately after the power off, the projector
may not be turned on while the LAMP
indicator is flashing in green.
• Before unplugging the power cord, make sure
that the fans are stopped.
Correcting the keystone distortion
A picture may be expanded on the upper side if
projected upward from the projector lifted up by
the foot adjuster. The projector can correct this
keystone distortion automatically.
Press KEYSTONE.
The keystone distortion is corrected
automatically.
To correct further, make the “Keystone”
adjustment on the menu.
30
AUTO SET
POINTER
PJ
MARKER
LASER
MENU ENTER
KEYSTONE
ON/STANDBY
R-CLICKL-CLICK
VIDEO CAMERARGB
RESET FREEZERESIZE
IndicatorsON/STANDBY
ON/STANDBY
KEYSTONE
ON/STANDBY MENU ENTER
SELECT/ADJUST
INPUT
ON
LAMP
TEMP