Filter
Top Products
5
Step 1: Insert one end of a Cat 5 Ethernet RJ45 Cable into the
LAN IN port of the PoE Injector, and connect the other
end of the cable to you network Switch or PC.
)
Note:
Do not mistake the LAN IN port with the POWER+DATA OUT
port. Plugging the Ethernet cable into the wrong Ethernet port
may cause serious damage to your network devices.
Step 2: Plug one end of the Power Adapter into the DC 48V
port of the PoE Injector and the other end into your
electrical outlet. The green PWR LED on the PoE
Injector should light up.
Step 3: Connect another Cat 5 Ethernet RJ45 Cable from the
PoE Injector’s POWER+DATA OUT port to the
POWER+DATA IN port of the Splitter.
Step 4: Insert one end of the DC Power Cable that is provided
into the DC OUT port of the Splitter, and the other end
into the corresponding DC port of the Network Device.
The PWR LED on the Splitter should light up.
Step 5: Connect the provided Cat 5 Ethernet RJ45 Cable from
the LAN OUT port of the Splitter to the RJ45 LAN port
of the Network Device.
)
Note:
Please make sure that the output is correct, as a different
voltage may destroy the device.
At this point, your Network Device should have power and data,
and function normally as shown in the figure below.