Filter
Top Products
16
10/100Mbps Fast Ethernet Switch
Note: The gure is to illustrate the application and principle. The power plug you get
from the package and the socket in your situation will comply with the regulation in
your country, so they may differ from the gure above.
After the device is powered on, it begins the Power-On Self-Test. A series of tests run
automatically to ensure the device functions properly. During this time, its LED indica-
tors will respond as follows:
All of the LED indicators will flash momentarily for one second, which represents a
resetting of the system.
The Power LED indicator will light up.
The Power LED should be lit up when the power system works normally. If
the Power LED is not lit, please check as follows:
Make sure the AC power cord connected the switch with power source 1.
properly.
Make sure the voltage of the power supply meets the requirement of the 2.
input voltage of the switch.
Make sure the power source is ON.3.
You are recommended to check the following items:
Make sure that the cable connectors are firmly plugged into the Switch 1.
and the device.
Make sure the connected device is turned on and working well.2.
The cable must be less than 100 meters long (328 feet).3.
Connection