Filter
Top Products
T
T
T
S
S
S
8
8
8
G
G
G
S
S
S
S
S
S
D
D
D
2
2
2
5
5
5
-
-
-
S
S
S
T
T
T
S
S
S
1
1
1
6
6
6
G
G
G
S
S
S
S
S
S
D
D
D
2
2
2
5
5
5
-
-
-
S
S
S
T
T
T
S
S
S
3
3
3
2
2
2
G
G
G
S
S
S
S
S
S
D
D
D
2
2
2
5
5
5
-
-
-
S
S
S
/
/
/
M
M
M
T
T
T
S
S
S
6
6
6
4
4
4
G
G
G
S
S
S
S
S
S
D
D
D
2
2
2
5
5
5
-
-
-
S
S
S
/
/
/
M
M
M
T
T
T
S
S
S
1
1
1
2
2
2
8
8
8
G
G
G
S
S
S
S
S
S
D
D
D
2
2
2
5
5
5
-
-
-
M
M
M
2.5” Solid State Disk
Transcend Information Inc.
V1.09
ATA
ATAATA
ATA Command Specifications
Command Specifications Command Specifications
Command Specifications
CHECK POWER MODE (E5h)
The host can use this command to determine the current power management mode.
EXECUTE DIAGNOSTICS (90h)
This command performs the internal diagnostic tests implemented by the drive.
FLUSH CACHE (E7h)
This command is used by the host to request the device to flush the write cache. If there is data in the write cache, that data
shall be written to the media. The BSY bit shall remain set to one until all data has been successfully written or an error
occurs.
FLUSH CACHE EXT (EAh)
48-bit feature set mandatory command. This command is used by the host to request the device to flush the write cache. If
there is data in the write cache, that data shall be written to the media. The BSY bit shall remain set to one until all data has
been successfully written or an error occurs.
IDENTIFY DEVICE (ECh)
This commands read out 512Bytes of drive parameter information. Parameter Information consists of the arrangement and
value as shown in the following table. This command enables the host to receive the Identify Drive Information from the
device.