Filter
Top Products
CPSMP-200
6
Tech Support: 1-800-260-1312 -- International: 00-1-952-941-7600 -- (24 hours)
WARNING: Do not connect the power supply module to the external power
source before installing it into the chassis. Failure to observe this caution could
result in equipment damage and/or personal injury or death.
Maintenance
Replace the CPSMP-200
NOTE: The CPSMP-200 power supply module may be “hot swapped” (i.e.,
replaced while the chassis is in operation) provided the module to be
replaced has been disconnected from its external power source and the
module’s On/Off switch has been set to “0”.
To replace the CPSMP-200 power supply module:
1. Ensure the On/Off switch on the power supply module is set to “0”.
2. Disconnect the AC power cord from the AC power source.
3. Remove the two (2) screws that secure the power supply module to the
chassis. Retain the screws for installing the replacement module.
4. Carefully slide the power supply module out of the chassis.
I
0
On/Off Switch
AC Power Cord
I
0
I
0
techsupport@transition.com -- Click the “Transition Now” link for a live Web chat.
7
5. Set the Primary/Secondary switch and the Management/Manual switch on
the replacement power supply module, if necessary (see page 3).
6. Carefully slide the replacement power supply module into the installation
slot, aligning the module with the installation guides.
7. Ensure that the power supply module is firmly seated inside the chassis.
8. Carefully install the two (2) retained screws through the power supply
module into the chassis, rotating clockwise to secure.
9. See the “Connect to External Power” section (page 5) for instructions on
re-connecting the power supply module to the external power source.
I
0
I
0
Primary/Secondary Switch
and
Management/Manual Switch