Filter
Top Products
After connecting the Switch to a power outlet, the LEDs do not turn on.
Check the connection of the external power adapter to the TEG-S80Dg and the power outlet.
Also check that the power outlet is receiving power.
When I connect a computer to one of the ports on the Switch, the Link/ACT LED turns on,
but I am not getting Gigabit speeds.
Check the LEDs. If the 100/1000Mbps LED is green, the computer's connection speed is
1000Mbps. If the 100/1000Mbps LED is amber, the computer's connection speed is
100Mbps. If the 100/1000Mbps LED is off, the computer's connection speed is 10Mbps.
2. Check the Ethernet Cable. Make sure you are using CAT-5e or CAT-6 Ethernet Cables.
Some CAT-5 cables are not rated to run in Gigabit.
3. Make sure that you have a Gigabit Ethernet Adapter installed on your computer.
After I connect my PCs to the Switch, I am unable to share files.
1. Check the LEDs on the Switch. Make sure the Link/ACT LED is on.
2. Check the network cable. The minimum length of the cable is 1.5 meters and the
maximum length of the cable is 100 meters.
3. Disable any software firewall program.
4. Verify that you have file sharing enabled. Please contact your Operating System support
for more information.
After I connect my PCs to the Switch, I can only get onto the Internet from one computer.
The Switch was not designed to share Internet between multiple computers. You need to get
an Internet router such as the TW100-S4W1CA.
Where is the uplink port located on the Switch?
Since all the ports on the Switch are Auto-MDIX, any of the ports can be used as an uplink
port.
If you still encounter problems or have any questions regarding the TEG-S80Dg please contact
TRENDnet's Technical Support Department.
1.
Troubleshooting
5