Filter
Top Products
Q2:
A2:
Q3:
A3:
I specified the IP address http://192.168.1.200 in my Internet Browser's
Address Bar, but an error message says "The page cannot be displayed". How
can I get into the TPL-210AP's web configuration page?
First, check your hardware settings again by following the instructions in
section 2. Second, make sure the Power, Home Plug and Wireless lights are lit.
Third, make sure the TCP/IP settings are configured properly (see Q1). Fourth,
since the Access Point's default IP address is 192.168.1.200, make sure that no
other network devices are assigned an IP address of 192.168.1.200.
If my network's IP is different than the Access Point's range, what should I
do?
You should still configure the Access Point first. After all the settings are
applied, go to the Access Point's configuration page, click on IP setting and
change the IP address of the Access Point to match your network's IP.
6
Troubleshooting
Q1: How do I configure TCP/IP settings on my computer?
1. Go into the Control Panel and double-
click the Network Connections icon,
right-click the Local Area Connection
icon and then click Properties.
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Use the following IP address, and
make sure you assign your network
adapter an IP address in the subnet of
192.168.1.x.