Filter
Top Products
Indicator Lights
All indicator light descriptions apply when the Line Conditioner is plugged
into a wall outlet and turned on. (Available on select models only.)
A green "NORM" light will turn ON whenever your Line Conditioner is
plugged in and receiving nominal AC line voltage.
Yellow lights labelled "LOW" (or "BOOST") and "HIGH" (or "TRIM") will turn
ON when incoming voltage is above or below nominal AC line voltage.
Red lights labelled "VERY HIGH" or "VERY LOW" will turn ON when
incoming voltage is substantially above or below nominal AC line voltage.
A green "LINE OK" light will turn ON when AC power is present and no
wiring faults are detected. When this light is illuminated, AC power is accept
able for connected equipment.
A red "LINE FAULT" light will turn ON to indicate a wiring fault has been
detected. The condition should be investigated and repaired by a qualified
technician as soon as possible. A loose wall outlet may cause this light to
come ON.Your Line Conditioner will identify most common wiring faults (but
not necessarily every possible type of fault).
Other Features
AC Receptacles
The receptacles provide your connected equipment with AC line power
during normal operation. They adjust incoming voltage to provide equip-
ment with nominal 220/240V power. The receptacles also protect your
equipment against damaging surges and line noise, eliminating the need
for external surge suppression.
Note: As the Line Conditioner corrects fluctuating input voltages, the
unit will make a gentle clicking sound.The frequency of the clicking
will depend on the quality of the utility power in your particular area.
The clicking is normal and indicates the Line Conditioner is
compensating for fluctuating input voltages as described in this manual.
Circuit Breaker (Available on select models)
If the rated capacity of the Line Conditioner is exceeded at any time,
the circuit breaker will open (trip). Remove the overload and let the
circuit breaker cool for one minute. Reset the circuit breaker by pushing
in the plunger.
Basic Operation
4
Line Conditioner Manual.qxd 7/2/2004 12:37 PM Page 4