Filter
Top Products
2-YEAR LIMITED WARRANTY
Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and
workmanship for a period of 2 years (except batteries outside USA and Canada, 1 year) from the date of initial purchase. If the product
should prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion.
Service under this Warranty can only be obtained by your delivering or shipping the product (with all shipping or delivery charges
prepaid) to: Tripp Lite; 1111 W. 35th Street; Chicago IL 60609; USA. Seller will pay return shipping charges. Call Tripp Lite Customer
Service at (773) 869-1234 before sending any equipment back for repair.
THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR
NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES
OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND
THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow
limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have
other rights which vary from jurisdiction to jurisdiction).
Tripp Lite; 1111 W. 35th Street; Chicago IL 60609; USA
WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use
intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the
suitability or fitness of these devices for any specific application.
Policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
ULTIMATE
®
LIFETIME INSURANCE POLICY (Valid in U.S. and Canada ONLY)
Tripp Lite warrants, for the lifetime of the product, (at Tripp Lite's option) to repair or replace (on a pro rata basis) directly connected
equipment that is damaged due to power transients while properly connected to Tripp Lite products offering the Ultimate
Insurance
Policy. Reimbursement or restoration for data loss is not included. Power transients include spikes and surges on the AC power, data, or
telephone lines that the Tripp Lite products have been designed to protect against (as recognized by industry standards).
AC Power Line Transients: To claim damages the Tripp Lite product must be plugged into a properly wired and grounded outlet. No
extension cords, or other electrical connections may be used. The installation must comply with all applicable electrical and safety codes
set forth by the National Electrical Code (NEC). Except as provided above, this warranty does not cover any damage to properly
connected electronic equipment resulting from a cause other than an "AC power transient". If user meets all of the above requirements,
Tripp Lite will repair or replace (at Tripp Lite's option) equipment up to the specified value (See Ultimate
Insurance Policy Limits). No
coverage is allowed for damage entering from telephone or data lines, unless they are separately protected as described below.
Telephone and Data Line Transients: Tripp Lite will repair or replace directly connected equipment that is damaged by transients
on telephone and/or data lines
only when all such paths are protected by a Tripp Lite protection product(s) and the AC power
(utility) line is simultaneously protected by a Tripp Lite power protection device (UPS, surge suppressor or line conditioner) with
Ultimate Insurance coverage. This product protects one line; therefore one directly connected piece of equipment.
Reimbursement dollar limits will be equal to that of the Tripp Lite power protection protector. Coverage is excluded where a suitable
environment for the protection device is not provided, including, but not limited to, lack of a proper safety ground. Telephone
service equipment must also include a properly installed and operating "primary protection" device at the telephone service
entrance (such devices are normally added during telephone line installation).
All above warranties are null and void if the Tripp Lite product has been improperly installed, tampered with or altered in any way, or
if the connected equipment was not used under normal operating conditions or in accordance with any labels or instructions. All claims
under this warranty must be submitted in writing to Tripp Lite within 30 days of the occurrence or the claim will not be considered. This
warranty does not include damage resulting from accident or misuse, and applies to domestic (USA & Canada) use of these products only.
Tripp Lite reserves the right to determine whether the damage to the connected equipment is due to malfunction of the Tripp Lite
product by requesting the equipment in question be sent to Tripp Lite for examination. This policy is above and beyond, only to the
extent needed, of that provided by any coverage of connected equipment provided by other sources, including, but not limited to,
any manufacturer's warranty and/or any extended warranties.
EXCEPT AS PROVIDED ABOVE, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of
implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE. Specifically, Tripp Lite is not liable for any costs, such as lost profits or revenue, loss of
equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes, claims by third parties, or otherwise.
To receive service under this warranty, you must be the original purchaser/user of the product in question. You must obtain a
Returned Material Authorization (RMA) number from Tripp Lite. Products must be returned to Tripp Lite with transportation
charges prepaid and must be accompanied by a description of the problem encountered and proof of date and place of purchase.
CONSUMER INFORMATION AND FCC REQUIREMENTS (U.S. only)
1. This equipment complies with Part 68 of the FCC rules. On the top or bottom of this equipment is a label that contains, among other
information, the FCC registration number for this equipment. If requested, provide this information to your telephone company.
2. If your Fax/Modem Protector causes harm to the telephone network, the telephone company may temporarily discontinue your
service. If possible, they will notify you in advance. But if advance notice isn't practical, you will be notified as soon as possible. You
will be advised of your right to file a complaint with the FCC.
3. Your telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of
your equipment. If they do, you will be given advance notice so as to give you an opportunity to maintain uninterrupted service.
4. If you experience trouble with this Fax/Modem Protector, please contact Tripp Lite Customer Support, 1111 W. 35th Street, Chicago,
Illinois 60609; Phone (773) 869-1234 for repair/warranty information. The telephone company may ask you to disconnect this
equipment from the network until the problem has been corrected or you are sure that the equipment is not malfunctioning.
5. This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state
tariffs. (Contact your state public utility commission or corporation for information.)
FCC RADIO/TV INTERFERENCE NOTICE (U.S. only)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction
manual, may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particualr
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference using one or more of the following measures: reorient
or relocate the receiving antenna; increase the separation between the equipment and the receiver; connect the equipment into an
outlet on a circuit different from that which the receiver is connected; consult the dealer or an experienced radio/television technician
for help. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly
approved by the party responsible for compliance could void the user’s authority to operate the equipment.
EQUIPMENT ATTACHMENT LIMITATIONS (models with the Industry Canada label in
Canada only)
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets the
telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment
Technical Requirements Document(s). The Department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications
company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that the
compliance with the above conditions might not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made
by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. Caution:
Users should not attempt to make connections themselves, but should contact the appropriate electric inspection authority, or
electrician, as appropriate.
7 • WARRANTY & INSURANCE
CORRECTION
Plug the UPS into a live
AC outlet. If power is not
present, make sure that
your building's circuit
breaker has not been acci-
dentally turned OFF
Unplug at least one piece
of equipment from any
Surge Protected Outlet.
Press the circuit breaker
button back into place
After saving files and
switching off your com-
puter, turn the UPS OFF
and charge the battery for
4 - 6 hours. Switching OFF
the UPS will prevent the
battery from unnecessary
draining
Unplug at least one piece
of equipment from the
Battery Backup Protected/
Surge Protected Outlets
4 • TROUBLESHOOTING
4.2 Maintenance & Service
The Internet Office 300 UPS contains no user-serviceable parts. If you require service which
goes beyond what is explained in the Troubleshooting Guide, call Tripp Lite Customer
Support at (773) 869-1234. Explain your problem, and a technical support person will either
remedy the problem over the phone or give you instructions about return, repair or
exchange. If returning your Internet Office 300 UPS to Tripp Lite, please carefully pack the
UPS using the ORIGINAL PACKING MATERIAL that came with the unit. Adequate packing
is essential to ensure your UPS is not damaged in transit. Enclose a letter describing the
symptoms of the problem. If the UPS is within the 2 year warranty period, enclose a copy
of your sales receipt.
SYMPTOM
All indicator lights are
OFF
Circuit breaker button
pops up
UPS does not provide ex-
pected run time
UPS Overload LED lights,
and is accompanied by a
constant audible alarm.
Run time is diminished
PROBLEM
UPS is not plugged into a
live AC outlet
The Surge Protected Out-
lets are overloaded
Battery is not charged
enough or has been de-
pleted by frequent power
outages
The Battery Backup Pro-
tected/Surge Protected
Outlets are overloaded
4.1 Troubleshooting Guide
Please check the following guide before sending your UPS in for service:
5 • SPECIFICATIONS
INTERNET OFFICE 300 UPS SYSTEM
Output Capacity (VA/Watts): ............................................. 300/150
Nominal Output (Voltage, Frequency): .............................. 120V, 50/60Hz (auto-sensing)
Nominal Input (Voltage, Frequency): ................................. 120V, 50/60Hz (auto-sensing)
Typical Backup Time: ............................................................ 4 - 12 min.
Battery Recharge Rate (to 90% charge): ............................ 4 - 6 hrs.
Transfer Time, Typical: .......................................................... 2 - 4 ms.
AC Outlets (NEMA 5-15R):.................................................. 6 (3 surge & 3 UPS/surge)
Weight With Battery: ............................................................. 4.4 lbs.
Dimensions (H x W x D, in.): ............................................... 2-5/8 x 11 x 4-1/2
Surge and Line Noise Protection:
Suppresses up to 6,000 volt spikes at current levels up to 19,500 amps. Spike suppression starts at voltages just above nominal peak line
values. Handles up to 240 joules. Clamping response time: <1 nanosecond. Spike protection in all three modes: Hot to Neutral, Hot to
Ground, and Neutral to Ground. Full time EMI/RFI noise suppression
Fax/Modem Protection:
Single-line modem/fax protection covers center two wires (1 pair) on RJ11/45.
Network Protection:
10Base-T/100Base-TX ethernet line protection on wires 1,2,3 and 6 of RJ45.
Agency Approvals:
The Internet Office 300 is UL-1778 listed (UPS System). It meets Canadian National Standards as certified by UL, as well as FCC Class
B specifications, + NOM.
6 • MOUNTING TEMPLATE
Use the diagram below to place two user-supplied fasteners in the desired mounting
surface. Fasteners must have 5/16" (8 mm) clearance above the mounting surface and be
able to support at least 5 lbs (2 kg). Use the fastener positions numbered "1" or "2" for
horizontal mounting, or the positions numbered "3" for vertical mounting.
93-1907 (200012035)