Tripp Lite 93-2899 Power Supply User Manual


 
2
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be
followed during the installation, operation, and storage of this product.
Failure to heed these instructions and warnings will void the product
warranty.
Important Safety Instructions
Installation
The PDU provides convenient multiple outlets, but it DOES NOT provide surge or line noise
protection for connected equipment.
The PDU is designed for indoor use only in a controlled environment away from excess moisture,
temperature extremes, conductive contaminants, dust or direct sunlight.
Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that eliminate
the connection to ground.
The power requirement for each piece of equipment connected to the PDU must not exceed the
individual outlet’s load rating.
The total power requirement for equipment connected to the PDU must not exceed the maximum
load rating for the PDU.
Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable
parts inside.
Do not attempt to modify the PDU, including the input plugs and power cables.
Do not attempt to use the PDU if any part of it becomes damaged.
Do not attempt to mount the PDU to an insecure or unstable surface.
Never attempt to install electrical equipment during a thunderstorm.
Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety or
effectiveness is not recommended. Do not use this equipment in the presence of a flammable
anesthetic mixture with air, oxygen or nitrous oxide.
Mounting the PDU
Note: The illustrations may differ somewhat from your PDU model. Regardless of configuration, the user must determine the fitness of
hardware and procedures before mounting. The PDU and included hardware are designed for common rack and rack enclosure types
and may not be appropriate for all applications. Exact mounting configurations may vary. Screws for attaching the mounting brackets
and cord retention shelf to the PDU are included. Use only the screws supplied by the manufacturer, or their exact equivalent (#6-32,
¼" flat head).
1-1 Attach the mounting brackets to the PDU.
1-2 (Optional) Attach the cord retention
bracket(s) to the PDU.
1-3 Attach the PDU to a vertical rail in your
rack or rack enclosure. (Use the mounting
hardware that came with your rack or rack
enclosure to attach the mounting brackets to
the rail.) Attach the included mounting buttons
to the PDU. Position the PDU as desired in the
rack enclosure, align the buttons with the rack
mounting slots, and slide the PDU into
position.
1-1 1-2 1-3
200904140 93-2899.indd 2 5/13/2009 4:10:12 PM