Filter
Top Products
8A
Mounting
WARNING! Mount your Inverter/Charger BEFORE DC
battery and AC power connection. Failure to follow these
instructions may lead to personal injury and/or damage
to the Inverter/Charger and connected systems.
Tripp Lite recommends that you permanently mount your Inverter/Charger in the configuration
illustrated below. The APS700HF features integral mounting brackets on the front and rear of the unit.
The user must supply mounting hardware and is responsible for determining if hardware and mounting
surface are adequate to support the weight of the unit. See page 3A for location warnings and cautions.
Using the measurements as shown in the diagram install two user-supplied fasteners , leaving the
heads slightly raised. Slide the unit over the fasteners to engage the mounting bracket slots . Tighten
fasteners. Install two additional fasteners over the remaining mounting bracket.
B
A
4.31 in.
(10.95 cm.)
10.93 in. (27.8 cm.)
A
B
C
C
200604211 APS700HF.qxd 6/2/2006 1:54 PM Page 8