Filter
Top Products
UPS Location Warnings
• Install your UPS indoors, away from excess moisture or heat, conductive contaminants,
dust or direct sunlight.
• For best performance, keep the indoor temperature between 32º F and 104º F (0º C and 40º C).
• Leave adequate space around all sides of the UPS for proper ventilation.
UPS Connection Warnings
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug the
UPS into itself; this will damage the UPS.
• Do not modify the UPS's plug, and do not use an adapter that would eliminate the UPS’s
ground connection.
• Do not use extension cords to connect the UPS to an AC outlet. Your warranty will be voided
if anything other than Tripp Lite surge suppressors are used to connect your UPS to an outlet.
• If the UPS receives power from a motor-powered AC generator, the generator must
provide clean, filtered output.
Equipment Connection Warnings
• Do not use Tripp Lite UPS Systems for life support applications in which a malfunction
or failure of a Tripp Lite UPS System could cause failure or significantly alter the
performance of a life-support device.
• Do not connect surge suppressors to the output of your UPS. This might damage the
UPS and will void the surge suppressor and UPS warranties. However, Tripp Lite has
approved the connection of extension cords and/or our HT3100PC Power Conditioning
Center at the output of this UPS for greater accessibility and to increase the number of
battery backup supported outlets.* The use of extension cords is approved for remote
power needs, as long as the extension cord is sized properly (by using properly gauged
wire) and properly connected (by having a 3-prong grounded plug on one end and a 3-
prong receptacle on the other end of this cord). The UPS itself must be directly
connected to a properly grounded wall outlet.
* The total number of components connected should not exceed the UPS capacity. This will overload your UPS system.
Battery Warnings
Batteries can present a risk of electrical shock and burn from high short-circuit current.
Observe proper precautions. Do not dispose of the batteries in a fire. Do not open the UPS or
batteries. Do not short or bridge the battery terminals with any object. Unplug and turn off
the UPS before performing battery replacement. Use tools with insulated handles. There are
no user-serviceable parts inside the UPS. Battery replacement should be performed only by
authorized service personnel using the same number and type of batteries (sealed Lead-
Acid). The batteries are recyclable. Refer to your local codes for disposal requirements or in
the USA only call 1-800-SAV-LEAD or 1-800-8-BATTERY (1-800-822-8837) or visit
www.rbrc.com for recycling information. Tripp Lite offers a complete line of UPS System
Replacement Battery Cartridges (R.B.C.). Visit Tripp Lite on the Web at www.tripplite.com/
support/battery/index.cfm to locate the specific replacement battery for your UPS.
• During hot-swap battery replacement, the UPS will not provide backup power in the
event of a blackout or other power interruptions.
• Do not operate UPS without batteries.
• When adding external battery packs to select models with external battery pack
connectors, connect only Tripp Lite-recommended battery packs of the correct voltage
and type. Do not connect or disconnect battery packs when the UPS is operating on
battery power.
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the
installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed these
warnings will void your warranty.
2
Important Safety Instructions
200507084 93-2474 SMARTONLINE HT OM.qxd 10/20/2005 11:11 AM Page 2