Filter
Top Products
Important Safety Instructions
Connection and Start-Up
Plug your UPS’s line cord into an
electrical outlet.
Your UPS must be connected to a dedicated circuit of
sufficient amperage. Note, however, that the select
models may be fitted with different plug types. Refer
to the “OP Rating/ Plug Rating” chart printed on the
top of your UPS.
Once your UPS is plugged in, the fan and all Indicator
Lights will turn ON. The “LINE” and “LOAD
ACTIVE METER” LEDs will illuminate and the UPS
will emit a beep to indicate normal operation. However,
power is not supplied to your UPS’s AC outlets until the
UPS is turned on.
Plug your equipment into your UPS.
Your UPS is designed to support audio/video systems
and their associated servers, Media Center PCs, and a
Tripp Lite HT3100PC or HT7300PC Power
Conditioning Center only. The total number of
components connected should not exceed UPS
capacity. This will overload your UPS system. You
will also overload your UPS if you connect household
appliances to the UPS's outlets.
Turn your UPS ON:
• Press the “ON/TEST” Button
• Hold it for several seconds until you hear a beep
• Release it
Your UPS will begin providing AC power to its outlets.
The “ON LINE” LED will illuminate.
Your UPS will function properly without these
connections.
Phone/Network Line Surge
Suppression (Select Models)
These RJ-45 jacks protect connected equipment from
surges on a phone or network line.* Using appropriate
network cords, connect your wall jack to the UPS jack
marked IN and your equipment to the UPS jack
marked OUT. Make sure that the equipment you
connect to the RJ-45 jacks is also protected on the AC
power line.
* Not compatible with PoE (Power Over Ethernet) applications.
CA
U
Risk of
See to
p
Your model may differ.
1
1
2
3
2
3
Your model may differ.
Installation
(continued)
4
Optional Connections
1
CAUTION
Risk of electric shock
See top of unit for cautionary ma
r
1
200608195 93-2615 HTR22-3U OM.qxd 10/19/2006 9:36 AM Page 4