Tripp Lite ISOBAR6ULTRANG Surge Protector User Manual


 
2
Do not use with life support appliances if a malfunction or failure could cause failure or
significantly alter the performance of the life-support device. Do not use in the presence
of a flammable anaesthetic mixture with air, oxygen or nitrous oxide.
Install your surge suppressor indoors, away from excess moisture, heat and dust.
Connect your surge suppressor to a three-wire, grounded AC power outlet. Do not
remove or modify the ground pin of the surge suppressor's plug. Do not use two-prong
adapters with the surge suppressor's plug.
Your surge suppressor does not require maintenance. Do not open your surge suppressor
for any reason. There are no user-serviceable parts inside.
Important Safety Instructions
Quick Installation
Plug surge suppressor into
a three-wire, grounded 120V
electrical outlet.
The surge suppressor cannot provide full
protection unless it is plugged into a properly
wired and grounded outlet. The
ISOBAR6ULTRAHG features a hospital
grade plug and outlets. Grounding reliability
can only be achieved when the
ISOBAR6ULTRAHG is connected to an
equivalent grounded receptacle marked
"Hospital-Only" or "Hospital-Grade."
Flip surge suppressor's ON
- OFF switch ON (switch will
light up.)
When this switch is lit, it indicates that AC
power is enabled at the surge suppressor's outlets.
Plug the power cords of your
electrical equipment into your
surge suppressor's outlets.
Your electrical equipment is now protected
from AC surges on the power line.
3
2
1
1
2
3
200301011 Smart 2200-3000 owners manual.qxd 2/7/2003 3:52 PM Page 2