Tripp Lite Series 5kVA Power Supply User Manual


  Open as PDF
of 6
 
3
Mounting (Rack)
4-Post Mounting
1
2
3
A
B
C
F
E
G
4
H
Connect the two segments of each shelf
A
using the included attached screws and
wing nuts
B
. Leave the screws slightly loose so that the shelves can be adjusted in
thenextstep.
Adjusteachshelftofityourrack,thenmounttheminthelowestavailablespaceof
your rackwith thescrews,nutsand washersprovided
C
. Note that the support
ledges should face inward. Tighten the wingnuts that connect the shelf segments
D
.
Attach mounting ears
E
tothefrontmountingholesofyourequipment
F
using
the screws provided
G
. The ears should face forward.
Using an assistant, lift your equipment and slide it onto the mounting shelves.
Attach your equipment to the rack by passing the screws, nuts and washers
(user-provided)
H
through its mounting ears and into the rack rails.
To mount your equipment in a 2-post rack, you must purchase aTripp Lite 2-Post
Rackmount Installation Kit (model: 2POSTRMKITWM, sold separately). See the
InstallationKit'sowner'smanualforcompletemountinginstructions.
Mountyourequipmentineithera4-postor2-postrackorrackenclosure.Theusermustdeterminethefitnessofhardwareandprocedures
beforemounting.Ifhardwareandproceduresarenotsuitableforyourapplication,contactthemanufacturerofyourrackorrackenclosure.
The procedures described in this manual are for common rack and rack enclosure types and may not be appropriate for all applications.
WARNING!
Transformer modules are extremely heavy! Use caution while lifting and mounting! User must properly
stabilize the module while lifting and mounting!
2-Post (Telecom) Mounting
B
D
1
4
2
3
 previous next