Tripp Lite SK120USB Surge Protector User Manual


 
2
Installation
Connect Your Surge Suppressor to the AC Power Line: Plug the surge suppressor directly into
a 3-wire grounded, 120V AC outlet.
Secure Surge Suppressor to Outlet Using Included Mounting Screw (SK30USB only):
Securing the surge suppressor to the outlet will prevent accidental disconnection. Remove the wall
outlet cover plate and plug in surge suppressor. Screw in the included mounting screw to attach
the surge suppressor to the outlet.
Check Your Surge Suppressor’s Diagnostic Indicator Lights: If your surge suppressor features
diagnostic LEDs or indicators, check them prior to connecting your equipment. They will indicate
various operating conditions when the surge suppressor is plugged into a live 120V AC outlet and
the surge suppressor’s power switch is on.
“PROTECTED” LED: Indicates the surge suppression components are intact and providing
complete protection against surges. If this LED does not illuminate, some of the surge suppression
components are not functioning, and the unit should be replaced. Visit www.tripplite.com/support.
Connect Your Equipment to the Surge Suppressor’s AC Outlets: Plug your equipment’s power
cords (including 2-wire devices) into the surge suppressor’s AC outlets. Select models feature
integrated safety covers which cover the outlets when not in use. Other models feature special
widely-spaced outlets to accommodate transformers without covering other outlets. DO NOT plug
in extension cords. DO NOT OVERLOAD the surge suppressor’s outlets. The surge suppressor can
accommodate a total equipment load of up to 15 amps (whether plugged into a single outlet or
spread out over multiple outlets).
USB Charging Ports: Two USB charging ports are capable of delivering up to 2.1 A total. This will
provide enough power to charge the most demanding devices, including smartphones, tablets and
MP3 players.
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords
or adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor
away from heat-emitting appliances such as radiators or heat registers. Do not install where
excessive moisture is present. Do not plug extension cords into it. Never install electrical,
telephone, network or coaxial wiring during a lightning storm. Do not drill into any part of the
housing or open the housing for any reason. There are no user-serviceable parts inside.
Important Safety Instructions
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety
or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
13-05-275 93-32C1-EN.indd 2 6/14/2013 9:23:41 AM