Filter
Top Products
3
Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user must determine
the fitness of hardware and procedures before mounting. If hardware and procedures are not suit-
able for your application, contact the manufacturer of your rack or rack enclosure. The procedures
described in this manual are for common rack and rack enclosure types and may not be appropriate
for all applications.
4-Post Mounting
Connect the two segments of each shelf using the
included screws and nuts . Leave the screws slightly
loose so that the shelves can be adjusted in the next step.
Adjust each shelf to fit your rack, then mount them in
the lowest available space of your rack with the
screws, nuts and washers provided . Note that the
support ledges should face inward. Tighten the screws
that connect the shelf segments .
Attach mounting ears to the front mounting holes
of your equipment using the screws provided .
The ears should face forward.
Using an assistant if necessary, lift your equipment
and slide it onto the mounting shelves. Attach your
equipment to the rack by using the appropriate
hardware through its mounting ears and into the
rack rails.
G
F
E
D
B
C
B
A
1
2
3
A
B
C
B
E
D
F
G
1
2
3
4
4
2-Post (Telecom) Mounting
If you desire to mount your UPS in a 2-post rack, a Tripp Lite 2-Post Rackmount Installation Kit
(Model: 2POSTRMKITWM, sold separately) will be required. Refer to the 2POSTRMKITWM
Owner's Manual for complete installation procedures.
200607114 93-2586 SMART2200RMXL2U OM.qxd 7/21/2006 2:04 PM Page 3